SkyFiles.net

Nfusion High Definition
digital receivers

If you own a different model, please do not use this software as it will most definitely harm your receiver and will render it inoperable.
 

I. Firmware:

To download the software. Either click on the link then select SAVE.  If you see a program listing instead of the SAVE window then Right Click on the link then select "Save Target As"
 
 
 

MAIN Software
09-Nov-2009


nf_hd_v1.3sR_25.zip
Right click the mouse the select
"Save Target As" option

Make sure to unzip the file before loading it into the receiver
 

Software loader.
09-Nov-2009

 

ST_Uploader_1_7.zip



Nfusion HD
Original Free to Air Software
NfusionHD/nf_HD_fac_h_1.0_016.zip


This is the original free to air only software.
 

 

 

 

 

 

 

DOWNLOAD
Nfusion

You will need Null Modem Cable

I. Downloading the Main software.

1. Turn the receiver off and connect the cable to the computer
2. Run Nfusion HD  software loader
4. Click on the OPEN icon
5. Select new software file (new bin file)
6. Click on Start Nfusion
7. You will see a message "Reboot your receiver". Click OK.
8. Turn the receiver ON.  You should see a progress bar.
Wait until the software is loaded completely. You should see the text WRITING then GOOD on the front panel and the receiver may reboot and show 0000.  If the text shows FAIL then you downloaded the wrong software or your mother board is not compatible with the new software.
 
II. Loading the Boot file
  • Run the Nfusion loader program
  • Click on MAIN button to switch it to BOOT
  • Click on OPEN and select the boot file you wish to download
  • click on Start Nfusion
  • Turn the receiver's power switch ON
  • You will see a progress bar, then you will see WRITING then GOOD on the front panel
 


 


How To Instructions
 

NfusionHD/NFusion_HD_Manual[1]


Wireless Setup
NetGear-Linksys Wireless Step-by-Step config.pdf
How to connect the HD board

Unplug the power
Remove cover.
Connect the white flat cable from the HD board to the white connector on the motherboard (its keyed).
Connect the black flat cable from the HD board to the black connector on the motherboard (its keyed)
Attach the HD board to the back panel using the screw and the nut provided.
Connect the small RG6 cable from the HD board to the IF output (LNBF loop through)